Citi

Fliegl CLG Dolly

Further information
Chassis central axle trailer
Fine-grained steel welded construction
Fifth wheel coupling, make of our choice for 2 kingpins. with ball bearing slewing ring, max. 20° stop
Predpei Rizxjfx Ad Hoc
Support on drawbar and dolly at the front
Wheel chocks with holder
Steel underride guard
Half-shell mudguards
Towing device central axle trailer
CLG under-coupler drawbar with tested 50 mm towing eyes to the dolly and to the motor vehicle, including drawbar lock on the truck!
Axles + suspension
BPW disc brake axles
Air suspension
for Swap Train version Standard Saddle height lowered approx. 1100 mm, saddle height raised approx. 1280 mm, saddle height approx. 1140 mm,
Brake system
2-line compressed air brake systemColor-coded cable routing for easy servicing.
Spring-applied parking brake
2 non-interchangeable coupling heads at the front, with connecting lines to the motorized trolley,
2 non-interchangeable coupling heads with Wendelflex connecting lines to the trailer
EBS, electronic brake system with EBS plug at the front, with connecting cable,
EBS Wendelflex connecting lines to the trailer
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
with lifting & lowering, ECAS, via truck control, Ecas CAN 2 bus required in the truckwithout Ecas CAN 2 bus in the truck, additional operating control required in the truck (not included in the scope of delivery):Electrical system with a pre-assigned cable and a distributor box. Operation with 15-pin socket pin 11 and 15 with 2 x 7-pin socket pin 7 and 5 Note! This version must still be technically tested in conjunction with the trailer, it is likely that the dolly and the trailer can only be raised and lowered together if this is not technically possible, operation is via WABCO eTASC with hold function in lowered position + auto-reset function (no power required from the truck).
Additional operation on the vehicle via WABCO eTASC + hold function in lowering position + auto-reset function (no power required from the truck)
Vehicle - driving stability system
ECAS only possible in conjunction with WABCO EBS.
Axle load detection via EBS-Canbus signal, for indication via display in driver's cab, truck must be prepared accordingly, no truck installed (no calibrated scales)
Brake release function from truck (via button) on PIN 14 and additionally via button on vehicle next to H & S valve, for releasing the brake when coupled, EBS power supply must be guaranteed!
with Can Router
Wheels and tires
275/70 R 22.5 tires of the manufacturer's choice
Steel rims, factory silver
Electrical system
24 volt, multi-chamber lights, amber LED lighting on the side
Side amber LED lighting coupled with the blinker Flashing side lights
2 white LED position lights at the front
2 white/red rear lane departure lights
2 x 7-pin interchangeable plugs at the front, with connecting cable,
2 x 7-pin non-interchangeable plugs with helical flex connection cables to the trailer
Cable + plug and/or socket for reversing camera system, depending on vehicle type
Operating instructions
Note! Please note the currently permitted route network!
Towing vehicle must be taken to the Triptis factory for approx. 1 week for adjustment of the towing bar!
Please note the CLG recommendation as per the appendixThe following is required before acceptance of the order: Submission of all relevant measurements and dimensions as per the Fliegl CLG form (see appendix) The coupling height of the planned trailer must be

Sludinājums tika tulkots automātiski, tāpēc tajā varētu būt dažas tulkošanas kļūdas.