The pneumatic device for butt welding

EVV SV-63P

The pneumatic butt welding device, type Sv‑63P, is equipped with a robust vertical frame that includes vertical clamping jaws and a sliding movable plate. Clamping is achieved via tandem cylinders, while the support plate on the static side is isolated from the base frame, which also carries the movable carriages. These carriages are connected to a horizontal cylinder for compressing the workpiece. The carriage movement is limited in both directions—both for compressing and opening—while the distance between the clamping jaws can be adjusted according to the cross-section or diameter of the workpiece. Clamping with the set jaw distance is controlled using foot switches. An additional control cabinet with switches and push-buttons allows for single or simultaneous clamping and supports both manual and automatic welding operations. After welding, the clamping jaws lift, and the carriages return to their initial positions. The welding parameters are set using a controller mounted on the side of the device. The welding voltage is regulated by thyristors, and the power transformer is fully encapsulated and water-cooled, connected to the contact jaws via laminated conductors. Inside the device, a power board with a thyristor and a main control board ensure smooth operation. On the device cover, a compressed air maintenance unit with a pressure regulator is installed to adjust the clamping force. The main switch to activate the unit is located on the controller for setting the welding parameters.
Bedpeyqr Sxjfx Afaoww

Sludinājums tika automātiski tulkots. Iespējamas tulkošanas kļūdas.