Zems iekrāvējs

Fliegl SDS 470 T mit Radmulden

Further information
Vehicle consisting of:
Chassis low loader semi-trailer
Welded steel construction, fifth wheel plate with interchangeable 2 kingpin and 2 kingpin positions
24 t. 2-speed support winch, single-sided operation, with straight lower section, without thrust compensation
Folding rear support
2 wheel chocks with holder
Aluminum side collision protection
Quarter-shell mudguards in front of and behind axle unit
1st pair of wheel recesses after gooseneck recessed in the low bed of the tramline area, slanted towards the entrance. Length at bottom approx. 1600 mm, depth of wheel recesses approx. 260 mm. Note! Frame in main beam area 260 mm higher than wheel recess.
2nd pair of wheel recesses between A and B axle. Bottom length approx. 350 mm, depth approx. 260 mm. Note! Frame in main carrier area 260 mm higher than wheel recess.
If wheel loaders are to be driven and the overall height is to be checked, we request a technical data sheet for the wheel loader types with exact details (if overall height is exceeded -> customer risk, approval required), (depending on the ground clearance under the machines, inserts in the wheel recesses are required by the customer).
Wheel recess cover can be pulled out from the main frame, with wooden inserts.
Widenings extendable to 3,000 mm (not in the rear slope and not in the wheel recesses below) (track width of the construction machinery or vehicles to be transported must not exceed the outer frame width of 2,550 mm)
Storage compartment for wooden planks on gooseneck, front transverse
Wooden planks 70 mm for widening to 3000 mm
Low loader lashing eyes
2 pairs of ring lashing eyes, 5 tons each at the front on the gooseneck
11 pairs of lashing rings at the top and sides, each 10 tons, embedded in the outer frame
2 x on gooseneck9 x in low loader bed distributed first lashing eye 250 mm from the front and last max. 250 mm from the rear, distance between lashing eyes not greater than 1100 mm
8 pairs of stake pockets embedded in the outer frame, inside 70 x 40 mm, or instead of stake pockets 5 to. Ring lashing eyes embedded in the floor
Axles + suspension
SAF drum brake axles
Axle/chassis laser-measured Reduction in tire wear and fuel consumption
Air suspension
Wheels and tires
235 / 75 R 17,5
at the manufacturer's discretion
Twin steel rims, factory silver
Brake system
2-line compressed air brake system
Spring-applied parking brake
EBS, electronic braking system with EBS socket at the front, without connecting cable
Attention: The trailer may only be towed by towing vehicles that guarantee the effectiveness of the ABS!
2 swap-proof coupling heads at the front, without connecting cable
with lifting & lowering valve
Axle load detection via EBS-Canbus signal, for indication via display in the driver's cab, truck must be prepared accordingly, no truck installed (no calibrated scales)
Nedpfxoi Ri Hco Ah Telh
Vehicle - driving stability system
Electrical system
24 volt, multi-chamber lights, amber LED lighting on the side
2 white position lights at the front
2 white/red rear lane departure lights
2 x 7-pin interchangeable sockets at the front, without connecting cable
1 x LED rotating beacon with holder, switched via parking light (removable light)
2 pairs of warning signs, double LED illuminated and extendable to 3,000 mm, removable with plug
Floor
Gooseneck with steel / checker plate covering
Storage box embedded in drive-over slope to gooseneck
Then with 70 mm softwood floor, in the wheel recesses underneath and in the wheel

Sludinājums tika tulkots automātiski, tāpēc tajā varētu būt dažas tulkošanas kļūdas.